Table of Contents
Advertisement
14
www.electrolux.com
Problem
A
or
shown instead of numbers
on the Temperature Dis‐
play.
The lamp does not work.
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the "FastFreeze"
or "Shopping", or after
changing the temperature.
Water flows on the rear
plate of the refrigerator.
Possible cause
The door is left open.
The temperature in the
appliance is too high.
Temperature sensor
symbol is
problem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastFreeze" or
"Shopping" is switched
on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Solution
Close the door. Refer to
"Door open alarm"
Contact a qualified electri‐
cian or contact the nearest
Authorised Service Centre.
Contact the nearest Author‐
ised Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze mode"
or "Shopping mode".
Refer to "Closing the door".
The compressor starts after
a period of time.
This is correct.
Advertisement
Table of Contents
