Faults
Drying time too long?
Display panel goes out
and Start button flashes.
Humidity in the room is
increasing.
Power failure.
Unusual noises when dry-
ing.
The dryer feels cold
despite drying.
* Depending on the model
If you cannot rectify the fault yourself by turning the dryer off and then on
Note:
again, please contact our after-sales service.
Cause/remedy
The fluff filter or the EasyClean filter may be dirty, which will make the dry-
■
ing time longer. Clean the fluff filter or the EasyClean filter.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
The optimum ambient temperature for drying is between 15 °C and 30 °C.
■
Outside of this range, the drying time may increase.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. Energy saving mode is active ~ Page 13.
Not a fault. Make sure the room is adequately ventilated.
The drying programme is stopped. Remove the laundry and spread it out, or
restart the programme.
Not a fault; see also ~ Page 29.
Not a fault. The dryer can dry effectively at low temperatures using a heat pump.
Faults and what to do about them
en
33