Advertisement
User instructions
2. Installation and hook-up
Remove the polystyrene basket retainers.
Position the appliance in the desired place of
installation. The back or sides of the dishwasher
may be placed up against walls or other furniture
units. If the dishwasher is installed near a heat
source, fit the special insulating panel to prevent
overheating and malfunction of the appliance. To
ensure stability, install integrated or built-under
dishwashers only under continuous worktops, and
screw them to the adjacent units. To facilitate the
installation procedure, the intake and drain hoses
can be positioned in any direction; make sure that
the hoses are not kinked, crushed or pulled too
tightly. Make sure to tighten the locking ring-nut
once the pipes have been placed in the direction
required. A hole at least 8 cm in diameter is
required to allow the power supply cable and pipes
to pass. Before putting the dishwasher into its
definitive position, turn on the water tap and check
that there are no leaks from the tap connection, the
dishwasher connection or the hose.
Level the appliance on the floor using its
adjustable feet. This operation is essential for
ensuring correct operation of the dishwasher.
11
Advertisement
