Sony TRINITRON KV-AR29M61 Service Manual page 204

continued
Connecting a DVD player to COMPONENT VIDEO (DVD) IN
terminal
1 Using an audio cable, connect R and L under COMPONENT VIDEO (DVD) IN on
your TV to the LINE OUT, AUDIO R and L output connectors on your DVD player.
2 Using a component video cable, connect Y, C
COMPONENT VIDEO (DVD) IN on your TV to the COMPONENT VIDEO OUT Y,
C , and C output connectors on your DVD player.
B R
3 Press DVD on the remote to watch the COMPONENT VIDEO (DVD) IN and
"DVD" will appear on your screen.
DVD player
COMPONENT VIDEO OUT
C C
R B
Notes
• If your DVD player can output interlace and progressive mode signals, select the interlace
output when connecting to COMPONENT VIDEO (DVD) IN on your TV. Your TV can receive
either 525i/60Hz or 625i/50Hz interlace signals.
• Some DVD player terminals may be labeled differently:
Connect
Y (green)
C (blue)
B
C (red)
R
• When both S VIDEO and VIDEO for VIDEO IN 1 or VIDEO 3 INPUT are connected at the
same time, S VIDEO is automatically selected. To view VIDEO, disconnect the S video cable.
• If you select "DVD" on your TV screen, the signal from the MONITOR OUT will not be output
properly. This does not indicate a malfunction.
26
Additional Information
S VIDEO OUT LINE OUT
R-AUDIO-L
Y
Component video cable (not supplied)
To (on the DVD player)
Y
C , P , C or B-Y
B B b
C , P , C or R-Y
R R r
, and C under
B R
VIDEO
Audio cable (not supplied)
TV rear panel
COMPONENT VIDEO (DVD) IN
R L Y C C
B R