Kenwood C-707i-S Instruction Manual page 14

Connecting the System
Detaching and attaching the speakers
You can detach the speakers from the main unit and position them as you like.
Before detaching or attaching the speakers, or replacing the speaker cords, always turn the system off and unplug the
power cord from the AC wall outlet. If there is a disc in the main unit, remove it.
When only one of the speakers is detached, the unit is unstable and can tip over when subjected to vibration or impact.
Take care whenever detaching or attaching speakers.
When attaching the speakers, make sure they are attached securely. Improper installation creates the risk of the speaker
falling.
Detaching the speakers
Placing a detached speaker on a fl at
surface
Lay the speaker onto the fl at surface with the side that
attaches to the main unit downwards.
The side of the speaker that attaches to the main unit has
non-skid feed.
The magnets used in the speakers may cause color irregularities on
TV or PC screens. Do not locate the speakers too close to a TV or PC.
14
C-707I
en02_c-707i.indd 14 en02_c-707i.indd 14
Hooks
Remove the speaker cords from the hooks on the
back of the main unit.
From the back of the speaker, move it as indicated by
the arrow.
Take care so you do not drop the speaker.
Detach the speaker from the main unit.
Side that attaches
to main unit
12/27/2007 3:14:37 PM 12/27/2007 3:14:37 PM