Reversing Door Opening Direction - LG LRDCS2603S Owner's Manual

18 INSTALLATION
Reversing Door Opening
Direction
NOTE
• To assist in the installation of the handle on the
right side, place a piece of masking tape near the
top of the handle before removing it.
• The appearance of the handle may vary from
what is shown in the illustrations.
Removing the Refrigerator Handles
1
Loosen the set screws
mm) Allen wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the refrigerator door and handle
using a 1/4 in. (6.35 mm) Allen wrench, and
remove the mounting fasteners.
3
Carefully loosen the plug buttons
with your fingers. The buttons can be
unscrewed with the fingers by rotating
them counter-clockwise and continuing
until they loosen and fall out The buttons
were installed without pressure, and for
this reason, they can be unscrewed using
your index finger, thumb or both. Install the
plug buttons
with a 3/32 in (2.5
that
on the left side.
4
Assemble the mounting fasteners
both ends of the handle using a 1/4 in.
(6.35 mm) Allen wrench.
5
Place the handle on the door by fitting
the handle footprints over the mounting
fasteners and tightening the set screws
with a 3/32 in (2.5 mm) Allen wrench.
Reversing the Doors
1
Remove the top hinge cover screws
Lift the hook (not visible), located at the
bottom of the front side of the cover ,
with a at-head screwdriver.
2
Rotate the hinge lever
top hinge free of the hinge lever latch
CAUTION
• When lifting the hinge, be careful that the door
does not fall forward.
at
.
clockwise. Lift the
.