Pre-Operation Inspection - RIDGID 56803 Operator's Manual

Pre-Operation Inspection

WARNING
To reduce the risk of serious injury from electrical
shock or other causes, and to prevent damage to
your equipment, inspect all equipment and correct
any problems before each use.
To inspect all equipment, follow these steps:
1� Power off your equipment�
2� Disconnect and inspect all cords, cables, and con-
nectors for damage or modification�
3� Clean any dirt, oil, or other contamination from your
equipment to ease inspection and to prevent it from
slipping from your grip during transportation or use�
4� Inspect your equipment for any broken, worn, miss-
ing, misaligned, or binding parts, or any other condi-
tion which might prevent safe, normal operation�
5� Refer to the instructions for all other equipment to in-
spect and make sure it is in good, usable condition�
6� Check your work area for the following:
• Adequate lighting�
• The presence of flammable liquids, vapors, or
dust that may ignite� If present, do not work in
area until sources have been identified and cor-
rected� The equipment is not explosion proof�
Electrical connections can cause sparks�
• A clear, level, stable, and dry place for the oper-
ator� Do not use the equipment while standing in
water�
7� Examine the job to be done and determine the cor-
rect equipment for the task�
8� Observe the work area and erect barriers as neces-
sary to keep bystanders away�
See additional product specific safety information
and warnings starting on page 10.
6 – English – CS6x