Advertisement
Contents
Connections
Audyssey MultEQ
®
XT32, Audyssey Dynamic EQ
These cannot be selected when you have not performed Audyssey
0
Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 129)
0
These cannot be selected when sound mode is "DTS Virtual:X" or sound mode that have "+Virtual:X" in the sound mode name.
0
Audyssey Dynamic EQ
®
, Audyssey Dynamic Volume
0
These cannot be selected when using the headphones.
0
"Restorer" cannot be selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
0
surround, "Restorer" cannot be used. (v p. 171)
Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 129)
0
No audio is output from PRE OUT or speakers for ZONE2.
In ZONE2, the audio can be played back when signals input from digital connectors (OPTICAL/COAXIAL) are in 2ch PCM format.
0
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM format. To play back the audio in ZONE2
0
irrespective of the input signal format, set "HDMI Audio" in the menu to "PCM". Depending on the played back device, the audio may not be played back
even with this setting. In that case, set the audio format to "PCM (2ch)" on the played back device. (v p. 237)
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
0
range of about 98.4 ft/30 m.
Front panel
Display
Playback
Settings
®
, Audyssey Dynamic Volume
Setup. (v p. 197)
®
®
and Audyssey LFC™ cannot be selected when sound mode is "IMAX DTS:X" or "IMAX DTS".
257
Rear panel
Tips
®
and Audyssey LFC™ cannot be selected.
Remote
Index
Appendix
Advertisement
