Direct Ip Calls; Call Hold; Call Waiting - Grandstream Networks HT-286 User Manual

HandyTone -286 User Manual
you phone is assigned with a PSTN-like number such as 6265556789, most likely you just follow the
rule to dial 16266667890 as if you were calling from a regular analog phone, followed by pressing #
or wait for 4 seconds.
5.2.2

Direct IP Calls

Direct IP calling allows two parties, that is, a HandyTone with an analog phone and another VoIP
Device, to talk to each other in an ad hoc fashion without a SIP proxy. This kind of VoIP calls can be
made between two parties if:
• Both HandyTone ATA and other VoIP Device(i.e., another HandyTone ATA or Budgetone SIP
phone or other VoIP unit) have public IP addresses, or
• Both HandyTone ATA and other VoIP Device are on the same LAN using private IP addresses,
or
• Both HandyTone ATA and other VoIP Device can be connected through a router using public
or private IP addresses (with necessary port forwarding or DMZ).
To make a direct IP call, first pick up the analog phone or turn on the speakerphone on the analog
phone, then access the voice menu prompt by dial "***" or press the button on the HandyTone-286,
and dials "47" to access the direct IP call menu. User will hear a voice prompt "Direct IP Calling" and
a dial tone. Enter a 12-digit target IP address to make a call. Destination ports can be specified by
using "*4" (encoding for ":") followed by the port number.
Examples:
If the target IP address is 192.168.0.160, the dialing convention is
Voice Prompt with option 47, then 192168000160
followed by pressing the "#" key if it is configured as a send key or wait 4 seconds. In this case, the
default destination port 5060 is used if no port is specified.
If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
Voice Prompt with option 47, then 192168001020*45062 followed by pressing the "#" key if it is
configured as a send key or wait for 4 seconds.
5.2.3

Call Hold

While in conversation, pressing the "flash" button on the attached phone will put the remote end on
hold. Pressing the "flash" button again will release the previously held party and the bi-directional
media will resume.
5.2.4

Call Waiting

Grandstream Networks, Inc
11
.