Table of Contents
Advertisement
Temporary Confidential
TH12XX.book Page 49 Wednesday, December 19, 2007 4:17 PM
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit's AC adaptor, then reconnect the base unit's AC adaptor. Remove the
batteries from the handset, and then insert the batteries into the handset again.
General use
Problem
The unit does not work.
I cannot register a cellular
phone to the base unit.
Cause/solution
L Make sure the batteries are installed correctly
(page 13).
L Fully charge the batteries (page 14).
L Check the connections (page 12).
L Unplug the base unit's AC adaptor to reset the
unit. Reconnect the adaptor and try again.
L The handset has not been registered to the
base unit. Register the handset (page 35).
L Depending on the compatibility of the cellular
phone, you may not be able to register it to the
base unit.
L Confirm that your cellular phone supports the
hands-free profile (HFP) specification. If it
does not, you cannot register it to the base
unit.
L Confirm that the Bluetooth feature of your
cellular phone is turned on. You may need to
turn this feature on depending on your cellular
phone.
L The Bluetooth technology on your cellular
phone may not be functioning normally. Turn
off and on your cellular phone.
L It may take more than 10 seconds to complete
registration after you have performed all
operations with the cellular phone. Wait until
the LINK TO CELL indicator stops flashing
and lights green.
L If your cellular phone is already connected to
another Bluetooth device such as a Bluetooth
headset, turn it off or disconnect it from your
cellular phone.
For assistance, please visit http://www.panasonic.com/help
Useful Information
49
Advertisement
Table of Contents
