Table of Contents
Advertisement
Operating Modes
A stand-alone mode will listen to sound and run through its diverse range of built in programs.
Master/Slave mode will allow the command of up to as many units you want in a synchronized
light show to the sound.
DMX control mode will provide the greatest flexibility and creativity. Each fixture trait can be
controlled individually using any universal DMX-512 controller.
M ast e r & St an d Al on e ( P 6)
In order to create the correct environment for Stand Alone
operation, several parameters have to be set in the control
panel. Please make the changes to the functions as listed in
the table below.
F
UNCTION
P6
P4
A
P1
P2
S et t i ng S lav e F i xt u re s
The Master/Slave mode will allow you to link multiple units in a daisy chain fashion. In this mode, the
first unit in the daisy chain, the master, will automatically command all other units following. The first
unit will operate in a Stand/Alone mode and all units following will synchronize to the first unit. Up to
16 fixtures can be daisy chained in Master/Slave mode.
M
S
ENU
P6
-n
P4
-n
A
001
P1
Any
P2
Any
You can change the Pan and Tilt settings freely.
Sou nd - act iv e ( P4 ) o r Au t o- run ( P 5)
In Master/Slave mode you can choose whether the fixture will run in a sound-active state where the
movement is triggered by sound or in auto-run where the speed is pre-programmed.
M
S
ENU
P4
-n
or
P5
-n
Q-Scan 250 & Q-Roll 250 User Manual
S
T
N
ET
O
OTES
-y
Master mode (one Master only)
-y
Sound activated
001
Channel address
Any
Pan invert
Any
Tilt invert
T
N
ET
O
OTES
Master mode
Sound activated
Channel address
Pan invert
Tilt invert
T
N
ET
O
OTES
Sound Activated
Auto-run
Note!
If the fixture is connected to a
controller, please disconnect it.
The display will read the previously
selected setting.
Only one fixture can be the Master
assigned fixture. However, 16 units
can be slaved to the master unit.
10
2005-11-15/13:24
Hide quick links:
Advertisement
Table of Contents
