Table of Contents
Advertisement
• ELECTRONIC CONTROLS
The controls will look like one of the following.
FAN SPEED
• Every time you push this button, it cycles through the settings as follows:
→
{High(F2)
Low(F1)
TEMP
MODE
Push this button to cycle through the modes from COOL → FAN
-
→ HEAT → COOL.
- COOL
• Fan runs continually for normal cooling operation.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the unit
will check the room air temperature to determine if cooling is
needed.
- FAN
• Fan operation without heating or cooling.
- HEAT
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature setting will raise 2°F after 30 minutes, and once again
after another 30 minutes.
• Push Timer to cycle through the settings from 1 Hour → 2 Hours → ... → 12 Hours maximum.
Copyright ©2012 LG Electronics. Inc. All right reserved.
Only for training and service purposes
→
→
High(F2)
Low(F1)}
E/SAVE
'
F
HEAT
FAN
FAN
HIGH
HIGH
COOL
COOL
LOW
LOW
TIMER
TIMER
MODE
FAN
TIMER
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
ON
ON
OFF
OFF
again.
• This button takes priority over any other button.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of 54
°F to 86°F by increments of 1°F.
• The setting appears in the display.
- 6 -
LGE Internal Use Only
Advertisement
Table of Contents
