Installation - Sony MEX-GS820BT Operating Instructions Manual

E:\Works\4698030111\4698030111MEXGS820BTUC\01GB-MEX-
GS820BTUC\040CD.fm
010COV.book Page 43 Thursday, March 23, 2017 2:51 PM
Notes on installing the connection cable
RC-SR1 (not supplied)
• Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper
connection may damage the unit.
• Depending on the type of car, be sure to insulate
the unused leads with electrical tape for safety.
• Do not connect this cable when the steering wheel
remote control is not used.
• Consulting the dealer or an experienced
technician for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [SET STEERING] to [PRESET]
(page 22).

Installation

Removing the protection collar
and the bracket
Before installing the unit, remove the
protection collar  and the bracket  from
the unit.
1
Pinch both edges of the protection
collar , then pull it out.

2 Insert both release keys  until they
click, and pull down the bracket ,
then pull up the unit to separate.


Face the hook inwards.
Mounting the unit in the
dashboard
• Before installing, make sure the catches on
both sides of the bracket  are bent
inwards 2 mm ( 3 / in).
32
• For Japanese cars, see "Mounting the unit
in a Japanese car" (page 44).
CAUTION
Do not touch the left side of the unit when
removing from the dashboard. The
heatsink on the left side of the unit
remains hot right after use.
1
Position the bracket  inside the
dashboard, then bend the claws
outward for a tight fit.
53 mm (2 1 /

2
Mount the unit onto the bracket ,
then attach the protection collar .

Notes
• If the catches are straight or bent outwards, the
unit will not be installed securely and may spring
out.
• Make sure the 4 catches on the protection collar
 are properly engaged in the slots of the unit.
masterpage: Right
1
182 mm (7 / in)
4
in)
8
Catch

43
GB
MEX-GS820BT
4-698-030-11(1)