Page of 12
Download Bookmark Comment

Glyph GT0501F-120 Quick Start Manual

Glyph gt0501f-120: quick start.
Also See for GT0501F-120:
Technical specifications - 1 page
Quick manual - 26 pages

   Also See for Glyph GT0501F-120

   Related Manuals for Glyph GT0501F-120

   Summary of Contents for Glyph GT0501F-120

  • Page 2

    This manual covers all SCSI Glyph products including the GT Series (GT 050 SCSI, GT 308 with hot-swappable SCSI drives), 1U rack, 2U rack, 3U Trip rack, tabletop SCSI drives, and SCSI drives in hot-swap trays. Since the general SCSI principles are the same throughout these product lines, this manual may not reference your exact product.

  • Page 3

    Your Glyph drive and accessories are packaged in a sturdy shipping container. Please inspect the container for evidence of shipping damage and mishandling. If such evidence is found, file a report with the carrier or your Glyph dealer immediately and do not attempt to unpack and operate the Glyph drive until the carrier or dealer confirms the damage.

  • Page 4

    There are many variations of Glyph tabletop and rack mounted SCSI configurations. If you don’t see yours in the diagram, don’t fret. The same principles apply to all Glyph SCSI drives. SCSI ID Switch...

  • Page 5

    SCSI ID Switch Power Button SCSI Connectors Power Input SCSI ID Switches Power Button Fans SCSI Connectors Power Input...

  • Page 6

    SCSI card manufacturer. Follow the instructions in the card’s manual for proper installation. If you have an incompatible card, Glyph can provide currently compatible cards for most applications. SCSI is an interface specification that facilitates high speed data transfer between devices.

  • Page 7

    Make sure that the power is off on all of your computer equipment and the Glyph drive. Connect the power cable to the back of the Glyph drive. Plug the three prong power plug into an appropriate power receptacle, preferably with...

  • Page 8

    SCSI cable to the SCSI card which you have already installed. Then connect the remaining 68 pin end to the back of the Glyph drive in either the top or bottom 68 pin connector. These two connectors are functionally...

  • Page 9

    This is accomplished by adding active termination to the peripheral devices. Active termination can be implemented in many different ways. Glyph has supplied a small rectangular 68 pin terminator that plugs into the remaining 68 pin connector on the end of the SCSI chain.

  • Page 10

    SCSI ID Selector Switch on your new Glyph drive. The Glyph tabletop’s SCSI ID Switch is located either on the front of the unit or on the back of the unit. The Glyph Hot Swap Tabletop’s ID Switch is found on the back of the unit, above the power cable input.

  • Page 11

    Check that you have: • A well ventilated location for the drive • The drive off and the power cord plugged into the drive • The SCSI cable connected to the SCSI card and the Glyph Drive. • Termination if necessary •...

  • Page 12

    Glyph Technologies • 227 Cherry St • Ithaca, NY 14850 607.275.0345 Fax 607.275.9464...

Comments to this Manuals

Symbols: 0
Latest comments: