LENCO PA-60 User Manual page 12

SOUND EFFECTS
- "PA-60" has a built in Equalizer
- Press and select the preset sound effect for your music; FLAT, CLASSIC, POP,
ROCK and JAZZ
TROUBLESHOOTING
General
No power
- Check that AC power cord is securely inserted in the unit and the electrical outlet.
- Check the Power On/Off switch is turn to On position.
- If battery is flat Plug in the AC Power cord to charge and operate.
Keys no response
- Turn the Power On/Off switch to Off, wait one minute and then On again to reset the
unit.
- Unplug the AC Power cord and plug it back again.
No sound heard
- Make sure the LINE connected volume is turn to reasonable level.
- Make sure the Bluetooth connected device output the audio via BT out.
- Make sure the Bluetooth connected device volume is turn to reasonable level.
Bluetooth Operations
Audio quality is poor
- Bluetooth reception is poor. Move the Bluetooth device nearer to the Speaker.
Cannot pair to Bluetooth device
- Make sure both Bluetooth device and Speaker is not connected to any other
Bluetooth device.
- Make sure the Bluetooth On/Off switch located below Speaker is slide to On position.
- Make sure the Blue LED on the Speaker is fast flashing (Pairing mode).
- Turn Power switch to Off, and then On again, Press and hold BT button for 2 seconds
to enter into pairing mode.
SPECIFICATIONS
General
Input Source:
Power consumption:
Bluetooth Range:
LINE IN:
USB Playback:
USB Recharging:
Control Buttons:
Bluetooth/LINE/FM/USB
20W
10M (33 feets)
3.5mm
Full Speed 2.0
1A
Power, Source, Bluetooth pairing, Volume Up/Down,
EQ, MIC (ECHO-/ECHO+), REP, LIGHT
12