Frigidaire FCRL3052ASB Installation Instructions Manual

Freestanding gas range
Hide thumbs Also See for FCRL3052ASB:

Advertisement

Available languages

Available languages

Quick Links

INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE
(For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only)
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE
• A child or adult can tip the range
and be killed.
• Verify the anti-tip device has been
installed to floor or wall.
• Ensure the anti-tip device is re-engaged when the
range is moved to floor or wall.
• Do not operate the range without the anti-tip device in
place and engaged.
• Failure to follow these instructions can result in death
or serious burns to children and adults.
Range
leveling leg
To check if the anti-tip bracket is installed properly,
use both arms and grasp the rear edge of range back.
Carefully attempt to tilt range forward. When properly
installed, the range should not tilt forward.
Refer to the anti-tip bracket installation instructions
supplied with your range for proper installation.
If the information in this manual
is not followed exactly, a fire or explosion may
result causing property damage, personal
injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone.
supplier's instructions.
• If you cannot reach your gas supplier, call
the fire department.
— Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
INSTRUCTIONS FOR FUTURE REFERENCE.
Tip Over Hazard
Anti-Tip
bracket
Follow the gas
Refer to your serial plate for applicable agency
certifications
Provide proper fuel type
Before proceeding: Your range is factory preset to oper-
ate on LP/Propane gas only.
Important notes to the installer
Read all instructions contained in these installation
instructions before installing range.
Remove all packing material from the oven
compartments before connecting the gas and electrical
supply to the range.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the consumer.
Important notes to the consumer
Keep these instructions with your Use & Care Guide
for future reference.
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
Special instructions for appliances installed in the State of
Massachusetts:
This appliance can only be installed in the State of
Massachusetts by a Massachusetts licensed plumber or
gas fitter. When using a flexible gas connector, it must
not exceed 3 feet (36 inches) in length. A "T" handle type
manual gas valve must be installed in the gas supply line
to this appliance.
1
809017003 Rev A (1904)

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire FCRL3052ASB

  • Page 1 INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Tip Over Hazard •...
  • Page 2: Important Safety Instructions

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) IMPORTANT SAFETY INSTRUCTIONS DO NOT MAKE ANY ATTEMPT TO OPERATE THE ELECTRIC IGNITION OVEN DURING • Installation of this range must conform with local codes AN ELECTRICAL POWER FAILURE.
  • Page 3 INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Tools you will need Tools (Wear safety glasses when using tools): For leveling legs and Anti-Tip Bracket: • Adjustable wrench or channel lock pliers (Fig. a) Fig.
  • Page 4 INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Installation with cabinets Check location where the range will be installed for proper electric and gas supply, and stability of the floor. The dimensions shown here 30”...
  • Page 5: Install Anti-Tip Bracket

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Install anti-tip bracket IMPORTANT SAFETY WARNING! (31.75mm) To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed an- ti-tip bracket and screws packed with the range.
  • Page 6: Provide An Adequate Gas Supply

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Provide an adequate gas supply. Connect range to gas supply. Please note: Operation at elevations above 2000 ft., Note: To prevent leaks use pipe joint sealant on all male appliance rating shall be reduced at the rate of 4 percent (outside) pipe threads.
  • Page 7: Checking Manifold Gas Pressure

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Checking manifold gas pressure c. Tighten the gas supply fitting and/or appliance conduit to flare union adaptor on the right side of the pressure Do not use flame to check for gas leaks.
  • Page 8: Electric Requirements

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Read the following electrical Check burner cap placement. connection details before It is very important to be sure that all surface burner caps connecting electricity to range.
  • Page 9: Check Ignition Of Surface Burners

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Check ignition of surface burners. 5/8” Burner flame size Operation of electric igniters should be checked after range and supply line connectors have been carefully Cooktop checked for leaks and range has been connected to elec- tric power.
  • Page 10: Make Sure Range Is Level

    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE (For Models with preset LP/Propane Gas Fuel and Sealed Top Burners Only) Adjust air shutter - lower oven. Make sure range is level. To determine if the oven burner flame is proper, remove Level the range by placing a level horizontally on an oven the oven bottom panel and lower burner baffle (Refer to rack.
  • Page 11: Para Su Seguridad

    INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) LA INSTALACIÓN Y EL SERVICIO (DE MANTENIMIENTO/REPARACIÓN) DEBEN SER REALIZADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: CONSERVE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD.
  • Page 12: Instrucciones Importantes De Seguridad

    INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) INSTRUCCIONES IMPORTANTES DE WARNING: NO INTENTE UTILIZAR EL ENCENDIDO ELÉC- SEGURIDAD TRICO DEL HORNO CUANDO HAYA UNA FALLA ELÉCTRICA. EN CASO DE FALLA ELÉCTRICA, RESTABLEZCA TODOS LOS •...
  • Page 13 INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Herramientas necesarias Herramientas (Utilice lentes de seguridad cuando use las herramientas): Para nivelar las patas e instalar el soporte antivuelco •...
  • Page 14 INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Instalación con gabinetes Verifique que el piso sea estable y que haya suministros eléctrico y de gas ade- cuados en la ubicación de instalación de la estufa.
  • Page 15: Instalación Del Soporte Antivuelco

    INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Instalación del soporte antivuelco SOPORTE DE FIJACIÓN (ÚNICAMENTE PARA INSTALACIÓN EN EL PISO) ¡ADVERTENCIA IMPORTANTE DE Más Pata de 1 1/4" SEGURIDAD! niveladora (3 cm)
  • Page 16 INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Proporcione un suministro Conexión de la estufa al suministro adecuado de gas. de gas. Tenga en cuenta lo siguiente: Para el uso de la estufa en altitudes Nota: Para evitar pérdidas, coloque sellador para juntas de tubería superiores a los 2.000 pies (610 m), el régimen nominal del electro- en todas las roscas macho (exterior).
  • Page 17 INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Verificación de la presión de gas del múltiple c. Apriete el accesorio del suministro de gas y/o el conducto del electrodoméstico al adaptador de unión al lado derecho del WARNING: regulador de presión (consulte la Fig.
  • Page 18 INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Lea la siguiente información de Verifique la colocación de la tapa conexión eléctrica antes de del quemador. conectar el suministro eléctrico a la Es muy importante asegurarse de que todas las tapas y rejillas de estufa.
  • Page 19 INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Verifique el encendido de los quemadores superiores. 5/8” Altura de la llama del quemador El funcionamiento de los encendedores eléctricos debe verificarse después de que se hayan controlado atentamente los conectores de Cubierta de la línea de suministro y de la estufa en busca de escapes, y de que...
  • Page 20 INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE INSTRUCCIONES DE INSTALACIÓN - ESTUFA INDEPENDIENTE (Solamente para modelos diseñados para funcionar con gas propano/gas licuado de petróleo y quemadores sellados) Ajuste del obturador de aire del Asegúrese de que la estufa esté horno inferior. nivelada.

Table of Contents