4.
Use drill bit of 5mm diameter and drill on the
marked positions, drill to have 3 cm depth
holes. Clean the holes after drilling.
`
J
Be careful not to get injured while drilling.
5.
Insert an anchor for each hole. Fully insert
anchors by hammering lightly the anchor
head with a hammer/rubber hammer.
6.
Place the wall-mount bracket on the desired
spot while setting its [▲ TOP] mark towards
direction of 12 o'clock and fasten screws
through the 4 holes using screwdriver.
`
n
For further steps, refer to the instructions for
"Wall Mounting Using Double-sided adhesive
tape".
12 · English
Desktop mounting
`
n
For more information about step of Separating the wall-mount bracket, refer to "Wall
Mounting Using Double-sided adhesive tape".
Assembling
1.
Assemble body bracket and wall-mount bracket while matching the [▼] and
[▲] marks.
2.
Turn the body bracket clockwise until it clicks, use the groove on the body
bracket.
3.
Connect the adaptor's plug to the power terminal on the camera's rear side.