Table of Contents
Advertisement
12
Finish assembling by
sliding the lower to
FRONT SLIDE Hinge Assembly
1.Locate the SLIDE hinge at the groove of the Front, then slide it toward the left to fix it.
2.Tilt the fixed SLIDE hinge to 45 degrees.
3.Move the SLIDE LOWER down to 1/2 position following the FRONT rail.
4.Slot the end of the hinge to the assembly groove of the LOWER, then bring Lower to the end to fix hinge
13
< Remove WINDOW
protection Vinyl>
※ caution
<right position>
Removing 3Mega CAMERA WINDOW protection vinyl and SLIDE ASS'Y Assembly
1.Remove 3MEGA CAMERA WINDOW protection vinyl.
2.Match the FPCB insertion hole of both SLIDE LOWER and FRONT.
3.Insert the FPCB through insertion hole to assemble SLIDE UPPER and FRONT
4.Push FRONT up to where it was
Place the end of the hinge at the
assembly groove
the end
< Match insertion
groove >
<wrong position>
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Exploded View/Disassembly&Assembly Instructions
Mind the
direction of
the hinge
Check whether FPCB
is at right position
5-13
Fix the hinge by sliding
it toward the left
<Critical point>
< Assemble SLIDE ASS'Y >
Advertisement
Table of Contents
