Table of Contents
Advertisement
4) ATX (ATX Power)
+12V
5V SB (Stand by +5V)
Power Good
GND
VCC
GND
VCC
GND
3.3V
3.3V
5) IDE1/IDE2 [IDE1 / IDE2 Connector(Primary/Secondary)]
IDE2
1
6) FDD (Floppy Connector)
1
Ø AC power cord should only be connected to
20
VCC
VCC
-5V
GND
GND
GND
PS-ON(Soft On/Off)
GND
-12V
3.3V
1
Ø Important Notice:
IDE1
1
Ø Please connect the floppy drive ribbon cables
- 17 -
your power supply unit after ATX power cable
and other related devices are firmly connected to
the mainboard.
Please connect first harddisk to IDE1
and connect CDROM to IDE2.
to FDD. It supports 360K,1.2M, 720K, 1.44M
and 2.88M bytes floppy disk types.
The red stripe of the ribbon cable must be the
same side with the Pin1.
Hardw are Installation Process
Advertisement
Table of Contents
