Table of Contents
Advertisement
Lint filter
@
Air inlet
H
Open the maintenance flap
P
Heat exchanger
WARNING
9
BEFORE INSTALLING OR USING YOUR DRYER
Read and follow all installation and operating
instructions.
Check the machine. Never connect the utilities (power or
water) to or start a damaged machine! Contact customer
service!
~ Customer service; Page 4
Check to be sure the dryer drain hose is installed
properly.
Turning the dryer on and off
The rotating Program Selector turns the dryer on as
drying cycle is selected and off when the selector is later
turned to the vertical Off position.
Before using the dryer for the first time
Read these operating instructions carefully.
1.
Check that the supply voltage corresponds with the
2.
voltage specifications on the rating plate on the dryer,
see top rear side of the dryer and/or rating plate label
inside of the dryer door.
~ Electrical Connections; Page 14
Remove all objects from the drum.
3.
machine on and when a drying cycle is selected the time
Close the maintenance flap
Check the dryer for visible damage. If damage found
4.
contact your dealer.
Wipe the inside of the drum with a damp cloth.
5.
Check heating system.
6.
~ Check heating system; Page 16
If the dryer does not work, switch the dryer to Off.
7.
Look in the Troubleshooting section of the operating
instructions for support.
~ Troubleshooting; Page 31
Temporary disconnection of the dryer
Operate your dryer only when you are at home. If you
intend going on vacation or are not using your dryer for
an extended period of time, you should:
Turn off the circuit breaker.
1.
Pull out the power supply plug if possible.
2.
Clean the lint filter.
3.
Using the program selector to choose a
drying cycle
NOTICE: If you have activated the childproof lock, you
must deactivate it before you can set a program.
~ Childproof lock; Page 24
Use the program selector to select the desired drying
cycle. This dial turns in both directions, switches the
duration appears in the display.
21
Advertisement
Table of Contents
