Gigabyte GA-8GE667 Pro User Manual page 22

8) FDD (Floppy Connector)
1
9) RAM_LED
+
10) PWR_LED
MPD+
1
11) 2X_DET
- +
GA-8GE667 Pro Motherboard
-
MPD-
MPD-
- 18 -
Ø Please connect the floppy drive ribbon cables
to FDD. It supports 360K,1.2M, 720K, 1.44M
and 2.88M bytes floppy disk types.
The red stripe of the ribbon cable must be the
same side with the Pin1.
Ø Do not remove memory modules while
DIMM LED is on. It might cause short or
other unexpected damages due to the 2.5V
stand by voltage. Remove memory modules
only when AC Power cord is disconnected.
Ø PWR_LED is connect with the system power
indicator to indicate whether the system is
on/off. It will blink when the system enters
suspend mode.
If you use dual color LED, power LED will turn
to another color.
Ø When an AGP 2X (3.3V) card is installed the
2X_DET will light up, indicating a non-
supported graphics card is inserted. Informing
users that system might not boot up normally
due to AGP 2X (3.3V) is not supported by the
chipset.