Gigabyte GA-73PVM-S2 User Manual page 75

After that, the Array List screen appears, displaying the RAID array that you have created (Figure 7).
(Note: BBS stands for BIOS Boot Specification. This indicates that the boot device is defined in the
BIOS.)
[Ctrl-X] Exit
To read more information about the RAID array, press <Enter> to enter the Array Detail screen (Figure
8), which shows various information about the array, including the RAID mode, stripe block size, hard
drive model name, and hard drive capacity, etc.
RAID Mode: Striped
Stripe Width : 2
Port
0.0
0.2
To clear MBR, press <C> in the Array Detail screen. When the "Clear MBR?" message appears, press
<Y> to clear or <N> to cancel.
To delete the array, press <D> in the Array Detail screen. When the "Delete array?" message appears,
press <Y> to confirm or <N> to cancel. Press <Enter> to return to the Array List screen.
To exit the NVIDIA RAID setup utility, press <Esc> in the main menu or <Ctrl>+<X> in the Array List
screen.
Now, you can proceed to the installation of the SATA controller driver and operating system.
MediaShield BIOS Jul 27 2007
Boot Status
BBS Healthy
[ ] Select [B] Set Bootable
Array 1: NVIDIA STRIPE 233.57G
Index Disk Model
0 ST3120026AS
1 ST3120026AS
[R] Rebuild [D] Delete
- Array List -
Vendor Array
NVIDIA STRIPE 223.57G
[N] New Array
Figure 7
- Array Detail -
Stripe Block: 64K
[C] Clear MBR
Figure 8
- 75 -
Size
[ENTER] Detail
Capacity
111.79GB
111.79GB
[ENTER] Return
Appendix