Free-Motion Quilting - Brother CE1125PRW Operation Manual

UTILITY STITCHES

Free-motion quilting

With free-motion quilting, the feed dogs can be
lowered (using the feed dog position lever) so that
the fabric can be moved freely in any direction.
The optional quilting foot is needed for free-motion
quilting.
Note
Models equipped with a needle threader
• Thread the needle manually when using the
quilting foot, or only attach the quilting foot after
threading the needle using the needle threader.
1
Remove the presser foot and the presser foot
holder. (Refer to page 24.)
2
Align the quilting foot with the lower-left side
of the presser bar.
The pin on the quilting foot should be
positioned over the needle clamp screw.
3
Hold the quilting foot in place with your right
hand, and then tighten the presser foot holder
screw using the disc-shaped screwdriver in
your left hand.
42
• Be sure to securely tighten the screws with the
4
5
6
1 Pin on quilting
foot
2 Presser foot
holder screw
3 Needle clamp
screw
7
1 Presser foot
holder screw
CAUTION
disc-shaped screwdriver, otherwise the needle
may touch the presser foot, causing it to bend
or break.
Slide the feed dog position lever to
1 Feed dog position lever
X The feed dogs are lowered.
Turn on the sewing machine, and then select
a stitch.
Use both hands to hold the fabric taut, then
move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of sewing.
After sewing is finished, slide the feed dog
position lever to and turn the handwheel
to raise the dogs.
• Normally, the feed dog position lever is
positioned at .
.
1 Pattern