Using The Capacitive Touchscreen; Navigating Using Gestures - Fujitsu LifeBook T904 User Manual

D
O NOT USE EXCESSIVE FORCE WHEN TAPPING ON THE SCREEN DURING CALIBRATION
LED /
AND OR TOUCH PANEL
Depending upon whether you are calibrating pen input or touch input, firmly touch the screen with the stylus or
5
your finger directly on the (+) symbol. Lift the stylus or your finger from the screen and the target will move to a
different location on the screen.
Repeat step 4 until you have selected all of the (+) symbols.
6
Once you have selected all the symbols, press the [OK] button.
7
Touch the stylus or your finger to various points on the screen to verify that the screen is correctly calibrated. If you
8
are not satisfied with the screen's calibration, press the [Calibrate]) button to begin again.

Using the Capacitive Touchscreen

This Tablet PC has a dual digitizer that allows you to use either the stylus or your finger(s) as a pointing device. This
type of display also allows you to use "gestures" to perform such actions as scroll, zoom, and rotate.
•
G
ESTURE SUPPORT IS DETERMINED BY THE APPLICATION IN USE
•
T
HE STYLUS TAKES PRECEDENCE OVER FINGER TOUCH
•
W
HEN ONE FINGER IS USED ON THE TOUCHSCREEN

Navigating Using Gestures

The touchpad allows you to use gestures to zoom in or out on a page, scroll quickly through large documents, toggle
the charms, toggle the application commands bar, and switch to last application.
Scrolling Up/Down:
To scroll up or down, slide two fingers up or down (Figure 27).
.
. I
F THE STYLUS IS WITHIN ACTIVE RANGE OF THE SCREEN
,
IT BEHAVES IN THE SAME MANNER AS A STYLUS
43 - Touchpad/Active Digitizer/Touchscreen
. U
SE OF EXCESSIVE FORCE COULD RESULT IN DAMAGE TO THE
.
,
FINGER TOUCH WILL BE DISABLED
.
.