AEG L8FEE945R User Manual page 14

Hide thumbs Also See for L8FEE945R:
Table of Contents

Advertisement

14
www.aeg.com
The display shows the indicator
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
If you touch the Start/Pause button,
the appliance performs the only
draining phase.
The appliance empties
the water out
automatically after 18
hours approximately.
• Drain only option (Skipping the
wash, rinse and spin phases) .
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator
spin) and the indicator
• Spin only option (Skipping the wash
and rinse phases) .
The appliance performs only the
spinning phase of the selected
washing programme.
The display shows the indicator
(cold), the phase indicator
spin speed.
If it is necessary to reduce
the spin speed, select a
programme with a lower
spin speed as default.
6.5 Stains/Prewash
Press this button repeatedly to activate
one of the two options or both.
The relevant indicator goes on in the
display.
• Stains
Select this option to pre-treat heavily
soiled or stained laundry using stain
remover.
Pour the stain remover into
compartment
.
(no
.
and the
. The stain remover is
pre-mixed and heated with detergent
in order to improve its effectiveness.
This option is not
available with a
temperature lower than
40 °C.
• Prewash
Use this option to add a prewash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
The options can increase the
programme duration.
6.6 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric creasing
and facilitates the fabric ironing.
The indicator
flashes on the display
during steam phase.
This option can increase the
programme duration.
When the programme stops the display
shows a zero
, the indicator
steady on and the indicator
flashing. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
button the anti-crease movements stop
and the door unlocks.
A small laundry load helps to
reach better results.
6.7 Delay Start
With this option you can delay the start
of a programme in a more convenient
time.
Touch the button repeatedly to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
is
starts

Advertisement

Table of Contents
loading

Table of Contents