D-Link DIR-2660 User Manual page 50

Section 4 - Configuration
The user can configure the IPv6 connection to run in IPv4 Tunnel mode. IPv6
over IPv4 tunnelling encapsulates IPv6 packets in IPv4 packets so that IPv6
packets can be sent over an IPv4 infrastructure.
Remote IPv4 Enter the IPv4 remote address you will use.
Address:
Remote IPv6 Enter the IPv6 remote address you will use.
Address:
Local IPv4 Displays the current local IPv4 address.
Address:
Local IPv6 Enter the IPv6 local address you will use.
Address:
Subnet Prefix
Enter the subnet prefix length supplied by your ISP.
Length:
IPv6 DNS Settings
Select either Obtain DNS server address automatically or Use the
DNS Type:
following DNS address.
If Use the following DNS address is selected:
Primary DNS Enter the primary DNS server address.
Server:
Secondary DNS
Enter the secondary DNS server address.
Server:
D-Link DIR-2660 User Manual
IPv6 in IPv4 Tunnel
46