Table of Contents
Advertisement
MFL34797048-en-8-ING 9/8/2008 3:54 PM Page 25
WATCHING TV
TURNING ON TV
First, connect power cord correctly.
1
At this moment, the TV switches to standby mode.
In standby mode to turn TV on, press the
I
I I N N P P U U T T , C C H H ( (
2
Select the viewing source by using the I I N N P P U U T T button on the remote control.
This TV is programmed to remember which power state it was last set to, even if the power cord is out.
I
When finished using the TV, press the P P O O W W E E R R button on the remote control. The TV reverts to standby mode.
3
!
NOTE
If you intend to be away on vacation, disconnect the power plug from the wall power outlet.
G G
CHANNEL SETUP
Auto Scan (Auto Tuning)
Automatically finds all channels available through antenna or cable inputs, and stores them in memory on the
channel list.
Run Auto Tuning again after any Antenna/Cable connection changes.
CHANNEL
Auto Tuning
Manual Tuning
Channel Edit
1
MENU
Select C C H H A A N N N N E E L L .
2
ENTER
Select A A u u t t o o T T u u n n i i n n g g .
3
ENTER
Select Y Y e e s s .
4
Run A A u u t t o o t t u u n n i i n n g g .
ENTER
, I I N N P P U U T T , ( (
) ) , N N u u m m b b e e r r ( ( 0 0 ~9 9 ) ) button on the remote control.
or
Move
Enter
or
) ) button on the TV or press the P P O O W W E E R R ,
D D E E
CHANNEL
Move
Enter
Auto Tuning
Manual Tuning
Channel Edit
Press 'Yes' button to begin
auto tuning.
Yes
No
5
RETURN
Return to the previous menu.
MENU
Return to TV viewing.
A password is required to gain access to
I
Auto Tuning menu if the Lock System is
turned on.
25
Advertisement
Table of Contents
