Table of Contents
Advertisement
TAPAS CASES SERVICE MANUAL / Rev. JUN. 2015
change to Celsius (°C), see point 4.2
Description of Buttons on the Controller
Changing the set point of the Temperature on the controller
The unit comes with a factory default set point (-8°F Freezers, 32°F Refrigerators). These set
values will make the unit perform at its maximum capacity. Therefore, it is not recommended
to change the set point. If set point needs to be changed, follow the next steps.
Note:
If you change the set point of temperature, the performance of the equipment will change. Changes made in
the parameters of the controller will not be covered under warranty.
1. -Push the SET button for one (1) second. You should see a flashing number. Release the
button.
2. Press the up and down arrows to increase or decrease the set temperature. Then press
the set button to save the new set point.
www.Fagorcommercial.com
To increase Set Point of Temperature
To turn t h e u n i t O N /OFF without
unplugging the equipment (press and hold 3
seconds)
To change the set point
To access programming mode
To decrease set Point of Temperature.
To set a manual defrost (press and hold 3
seconds),
Page8
Advertisement
Table of Contents
