Whirlpool SWA1040Q User And Care Manual page 42

Installation of interior unit (evaporator)
1. Installation of the mounting plate
 Choose a location to install the mounting plate, considering the position of the indoor unit and the direction of the pipeline.
 Adjust the mounting plate horizontally with a horizontal level ruler or a plumb bob.
 Make 32 mm (1 ¼ ") deep holes in the wall to fix the plate.
 Insert the plastic plugs into the holes and then fix the mounting plate with threaded screws.
 Check the mounting plate is firmly fixed. Then make a hole for the pipe.
NOTE: The shape of the mounting plate may be different from that shown in the illustration, but the installation system is
similar.
2. Hole for the pipe
 Decide the location of the pipe hole according to the position of the
mounting plate.
 Make a 70 mm hole in the wall. The hole must be slightly tilted down
and out.
 Install the plastic sleeve in the hole on the wall to keep it clean and
looking good.
3. Installation of indoor unit piping
• Pass the cables (liquid pipe and gas pipe) and cables through the hole in the wall from the outside or pass them from inside after
having completed the inner pipe and cable connections to connect the outer unit.
• Decide if you will cut the plastic part according to the direction of the pipe (as shown below).
Soften the edges that cut
Once the necessary pipe connections have been made, install the drain hose. Then connect the electrical power supply cables. After
making the connection, wrap the pipe, cables and drain hose together with thermal insulation material (included in your product).
Tapping screw
Mounting plate
Sleeve for hole on the wall (hard
polyethylene pipe, (provided by
client)
(downwards inclination)
19