Table of Contents
Advertisement
Available languages
Available languages
WHAT WATER MAY BE USED ?
Your iron has been designed to operate using untreated tap water. If in doubt, check with your
local water authority. However, if your water is very hard, you can mix 50% untreated tap water
with 50% distilled or demineralised water.
The types of water listed below contain organic waste or mineral elements that can
cause spitting, brown staining or premature wear of the appliance: water from tumble
dryers, scented or softened water, water from refrigerators, batteries or air
conditioners, pure distilled or demineralised water or rain water should not be used in
your iron. Also do not use boiling, or bottled mineral water.
IMPORTANT Heat concentrates the elements contained in water during evaporation.
USE
1 • Filling the water tank
2 • Setting the temperature
• Before filling
the water tank,
unplug the iron.
• Your iron is equipped with the Autosteam function, it automatically
adjusts the steam amount and the temperature based on the selected
fabric for optimum results.
• Select the fabric to be ironed on the thermostat dial. For perfect re-
sults, an optimum position for each fabric has been pre-defined. This
position is marked on the dial and also represented with a louder
"click" sound. You can also set your iron based on the international
temperature measurements •, ••, •••. Ensure your thermostat dial is
positioned on these settings.
• When your iron reaches the required temperature, the thermostat in-
dicator turns off.
• You can start ironing.
IMPORTANT The iron takes longer to cool down than to heat up.
We recommend that you start with fabrics to be ironed at a low
temperature.
For mixed fabrics set the temperature for the most delicate fabric.
• Open the filling
inlet. Fill in water
up to the Max.
mark. Close the fil-
ling inlet and return
the iron to the hori-
zontal position.
5
• Set the temperature
control dial on Min.
mark.
• Plug in
your iron.
* depending on model
Advertisement
Table of Contents
