Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hisense WFBL7014V
Summary of Contents for Hisense WFBL7014V
- Page 1 XxxxxxxA...
-
Page 3: Safety Information
SAFETY INFORMATION For appliances with ventilation openings in the base, that a The manufacturer reserves the right for any modifications carpet must not obstruct the openings. on the product which might be deemed necessary or Children of less than 3 years should be kept away unless useful without informing about it in this IFU. - Page 4 ensure Ensure Ensure that the ventilation openings in the base of the washing machine (if available on your model) are not obstructed by a carpet or other material. Single inlet - only Dual inlet - and cold...
- Page 5 that that The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for there cyclingof electrical and electronic equipment.
-
Page 6: Description Of The Washing Machine
BEFORE THE FIRST WASH CYCLE Clean the outside of the washing machine with a damp cloth. Do not use abrasive detergents. To remove any residual water used during testing by the manufacture r, we Never open the door forcibly or use it as a step. recommend that you carry out a short wash cycle without laundry. - Page 7 Open the door. / soak...
-
Page 8: Draining Residual Water
unds Press the release lever in the main wash compartment downward and remove the drawer(fig.“B”). Select the “Rinse+Spin” programme,reduce the speed to 1000rpm and strat Remove siphon in softener slot. (fig.“C”). Refit the siphon in the detergent drawer and fit the drawer back inside its housing. DRAINING RESIDUAL WATER (depends on model) Before emptying the residual water, switch the appliance off and unplug it... - Page 9 Put a flat container under filter door and then drain with emergency drain pipe (see [draining residual water] for specific operation methods). Then, loosen filter anticlockwise and completely unscrew and remove the filter. Check the supply hose regularly for brittleness and cracks and replace it if necessary using a new hose of the same type(available from After-Sales Service or specialist dealer).
- Page 10 solv and the power switched remove some...
- Page 11 Hot / Cold fill fault - For Models with Dual Inlets Fault Code List If you wish to connect hot and cold water supply (Fig.1): Displayed on Display Window Fault Description 1 Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red filter on the rear side of machine.
-
Page 12: Fault Code
TRANSPORT/HANDING C. Fault code The washer stops when the program is running. The display window shows fault code “F13”, “F14”, “F24”, else fault codes from “F04” to “F98” or “Unb”. If fault code “F13” is shown Door lock is abnormal. Start program for 20 sec and unlock the washer door (PTC) to check whether the door is closed.