Table of Contents
Advertisement
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Set clock
1
In standby mode, press and hold CLOCK
on the remote control for more than two
seconds.
» [24H] or [12H] hour format is
displayed.
2
to select [24H] or [12H]
Press
/
hour format.
3
press CLOCK to confirm.
» The hour digits are displayed and begin
to blink.
4
Repeat steps 2-3 to set hour and minute.
Note
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•
You can view clock information in power-on mode by
pressing CLOCK.
8
EN
Turn on
Press .
» The unit switches to the last selected
source.
Switch to standby mode
Press
again to switch the unit to standby
mode.
» The clock (if set) is displayed on the
panel.
Switch to ECO standby mode:
Press and hold
for more than two seconds.
» The display panel is dimmed.
Note
•
The unit switches to Eco Power Standby mode after 15
minutes in standby mode.
Switch between standby mode and ECO
standby mode:
Press and hold
for more than two seconds.
Advertisement
Table of Contents
