Power On The Extender; Set Up The Extender; Method 1: Via The Wps Button - TP-Link RE200V4 User Manual

Chapter 2
2 1

Power On the Extender

Plug the extender into an electrical outlet
Power LED turns solid on.
Note:
1. For safety, only plug the extender in upright direction as shown below.
2. The operating temperature should be between 0°C and 40°C.
2 2

Set Up the Extender

There are three ways to set up the extender: via the WPS button, via the TP-Link Tether
app, or via a web browser.
2 2 1

Method 1: Via the WPS Button

Use this way if your router has a WPS button. The button might look like one of these:
.
1. Press the WPS button on your host router, and then press the WPS button on the
extender for 1 second within 2 minutes.
Note:
For more information about using WPS button on your host router, please refer to the router manufacturer's user
guide.
2. Wait until the WPS LED
solid on, which indicates that the WPS connection is successful.
Note:
next to
changes to solid on, and wait until the signal LED
Set Up Internet Connection
your router, and then wait until the
On
turns
6