Table of Contents
Advertisement
Quick Links
VHMD SERIES
HumidiHeat™
HOLDING & TRANSPORT CABINETS
MODELS:
VHMD5
VHMD13
VHMD15
For additional information on Vulcan-Hart or to locate an authorized parts
and service provider in your area, visit our website at
VULCAN-HART
DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC.
www.vulcanhart.com
OPERATION MANUAL
ML-138046
ML-138045
ML-138044
Vulcan ©2009 All Rights Reserved
INSTALLATION &
www.vulcanhart.com
3600 NORTH POINT BLVD.
BALTIMORE, MD 21222
F-41161 (10-09)
Advertisement
Table of Contents
Related Manuals for Vulcan-Hart ML-138046
Summary of Contents for Vulcan-Hart ML-138046
- Page 1 VHMD5 ML-138046 VHMD13 ML-138045 VHMD15 ML-138044 For additional information on Vulcan-Hart or to locate an authorized parts and service provider in your area, visit our website at www.vulcanhart.com VULCAN-HART 3600 NORTH POINT BLVD. DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC.
-
Page 2: Important For Your Safety
VHMD SERIES F-41161 (10-09) IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START- UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITYOF THIS OR ANY OTHER APPLIANCE. -
Page 3: Table Of Contents
VHMD SERIES F-41161 (10-09) TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY ........1 GENERAL . -
Page 4: General
VHMD SERIES F-41161 (10-09) GENERAL UNPACKING: INTRODUCTION The Cabinet was inspected before leaving the factory. The transportation Vulcan-Hart HumidiHeat™ Holding & company assumes full responsibility for Transport Cabinets are produced with safe delivery upon acceptance of the quality workmanship material. -
Page 5: Electrical Requirements
VHMD SERIES F-41161 (10-09) Install tray slides in the cabinet. ELECTRICAL REQUIREMENTS Ensure that the hook on the end ELECTRICAL CODES & STANDARDS: of the tray slide is up. cabinet must installed accordance with: CLEANING: The cabinet should be thoroughly In the United States of America: cleaned prior to putting into service. -
Page 6: Lockout / Tagout Procedure
VHMD SERIES F-41161 (10-09) receptacle proper grounding type, contact electrician. DO NOT REMOVE THE GROUNDING PRONG FROM THIS PLUG. Verify that the power source matches the Serial Data Plate located on the lower back corner of cabinet plug configuration before the connection is made. -
Page 7: Operation
VHMD SERIES F-41161 (10-09) OPERATION the temperature. Holding temperature CONTROLS range is from 80⁰F. to 200⁰F. OPERATING INSTRUCTIONS Connect to proper electrical supply as indicated on data plate. Fill water into Water Reservoir. (Reservoir holds approx. 1 gallon or 3.78 liters of water.) The water level can be observed through the sight glass. -
Page 8: Shut Down
VHMD SERIES F-41161 (10-09) As humidity is increasing to the CLEANING desired setting, the Humidity Control Sensor Light will be lit RED. When Always UNPLUG desired humidity been ELECTRICAL POWER SUPPLY reached, the light will change to before cleaning. GREEN. DAILY: NOTE: Unplug electrical power supply. -
Page 9: Stainless Steel Care
VHMD SERIES F-41161 (10-09) HEAVY-DUTY CLEANING: Never rub in a circular motion. For heavy-duty cleaning, use warm Always rub gently in the direction water, a degreaser, and a plastic, of the steel grain. stainless steel, or Scotch-Brite pad. Never rub in a circular motion -- rub Never leave any food products gently in the direction of the steel grain. -
Page 10: Troubleshooting
Glass. Fill water in water reservoir. SERVICE & PARTS INFORMATION To obtain Service and Parts information concerning this model, contact Vulcan-Hart Service Department at the address listed on the front cover of this manual or refer to our website: www.vulcanhart.com... -
Page 11: Specifications
VHMD SERIES F-41161 (10-09) SPECIFICATIONS WIDTH SHIPPING DEPTH HEIGHT MODEL No. IN (mm) IN (mm) (mm) VOLTS WATTS AMPS Lb. (kg) 170# VHMD5 32.375" 34.25" 25.125 (77kg) 1200 340# 59.375" 34.25" 25.125" VHMD13 (154kg) 1200 (1700mm) (857mm) (724mm) 65" 370# (1702 34.25"... -
Page 12: Wiring Diagram
VHMD SERIES F-41161 (10-09) WIRING DIAGRAM...