Table of Contents
Advertisement
Setting the date and time
Set the date/time so that the correct date and time can be assigned to incoming calls, and to
enable the alarm to be used.
¤
Press the display key Time
or, if the date and time have already been set:
¤
. . . use
Time
OK
The active cursor position flashes
with
. . . switch between cursor positions with
Enter date:
¤
. . . enter the day, month and year in 8-digit format with
e. g.
Enter time:
¤
. . . enter hours and minutes in 4-digit format with
e. g.
To save settings:
¤
Press the display key Save. . . . the message Saved is shown in
the display and you hear a confirmation tone
Returning to idle status:
¤
Press and hold the End call key
The telephone is now ready for use.
Connecting the headset
¤
Connect the headset with 2.5 mm jack to the left side of the
handset
.
1
For information on recommended headsets, see the relevant
product page at
www.gigaset.com/s850.
The headset volume corresponds with the setting for the receiver
volume (
p. 57).
Connecting the USB data cable
For data exchange between the handset and PC:
¤
Connect the USB data cable with micro-USB plug into the
USB socket at the bottom of the handset
Connect the handset directly to the PC, not via a
USB hub.
to select
Settings
. . . change cursor position
for 07:15 .
OK
Date/
,
for 15/08/2014.
,
.
1
Getting started
Calls
Time
Date/Time
Date:
15/08/2014
Time:
00:00
Back
1
1
Save
9
Advertisement
Table of Contents
