HP Thin Client T740 Hardware Reference Manual page 30

5. Remove the stand from the thin client.
6. Lay the unit flat on a stable surface with the right side up.
7. Remove the thin client access panel. See
WARNING!
to cool before you touch them.
8. Locate the USB flash drive port on the system board.
9. Align the USB flash drive with the USB port and press the drive firmly into the port until it is securely
seated.
10. Replace and latch the access panel, and then reinstall the rear I/O panel. See
the access panel on page
11. Replace the thin client stand.
12. Reconnect the AC power cord and turn on the thin client.
13. Lock any security devices that were disengaged when the thin client access panel was removed.
24 Chapter 3 Hardware changes
To reduce risk of personal injury from hot surfaces, allow the internal system components
16.
Removing and replacing the access panel on page 16.
Removing and replacing