SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. •...
• Do not put electrical appliances (e.g. ice cream • Before maintenance, deactivate the appliance makers) in the appliance unless they are stated and disconnect the mains plug from the mains applicable by the manufacturer. socket. • Be careful not to cause damage to the •...
SWITCHING OFF • appliance location. Keep touching the temperature regulator button for 1. Touch temperature regulator. 3 seconds. Current temperature indicator blinks. Any time you All indicators light off. touch the temperature regulator, the setting moves by one position. The corresponding LED blinks for TEMPERATURE REGULATION a while.
HINTS AND TIPS NORMAL OPERATING SOUNDS • do not store warm food or evaporating liquids in the refrigerator The following sounds are normal during operation: • do cover or wrap the food, particularly if it has a • A faint gurgling and bubbling sound from coils strong flavour sound when refrigerant is pumped.
PERIODS OF NON-OPERATION This operation will improve the performance of the appliance and save electricity consumption. When the appliance is not in use for long periods, take the following precautions: DEFROSTING OF THE REFRIGERATOR 1. Disconnect the appliance from electricity Frost is automatically eliminated from the supply.
Page 8
Problem Possible cause Solution The lamp is defective. Contact the nearest Authorised Service Centre. The compressor operates con- Temperature is set incorrect- Refer to "Operation". tinually. Many food products were Wait some hours and then check put in at the same time. the temperature again.
Problem Possible cause Solution Temperature cannot be set. The "QuickChill " is switched Switch off "QuickChill " manually, or wait until the resets automati- cally to set the temperature. Re- fer to "QuickChill ". The temperature in the appli- The temperature regulator is Set a higher/lower temperature.
1. Connect the wire coloured green and yellow to Some functional problems might occur the terminal marked either with the letter “E“ or for some types of models when by the earth symbol or coloured green and operating outside of that range. The yellow.
TECHNICAL DATA TECHNICAL DATA Dimensions of the recess Height 1780 Width Depth Voltage Volts 230 - 240 Frequency The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENTAL CONCERNS with the symbol with the household waste.