Installation Instructions - Electrolux EFLW317TIW Installation Instructions Manual

Leveling your washer
Excessive noise and vibration can be prevented by
properly leveling the washer.
1. For free standing installation and with the
washer within 4 feet (1 m) of its fi nal location,
place a level on top of the washer.
2. Use the universal wrench to adjust the leveling
legs so the washer is level front-to-rear and
side-to-side, and stable corner-to-corner.
3. Press down on alternate corners and sides
and feel for the slightest movement. Adjust the
appropriate leg(s) so the washer sits solidly on
the fl oor on ALL four legs. Keep the leveling leg
extension at a minimum for best performance
of the washer.
NOTE
For pedestal installations, see additional
installation instructions included with the
pedestal.
Connecting inlet water
1. Run some water from the hot and cold
faucets to fl ush the water lines and remove
particles that might clog the water valve
screens and to determine which faucet is hot
and which is cold supply.
RUBBER WASHERS
MUST BE PRESENT
NOTE
Hoses are not included with washer purchase.
See "Accessories" section for various inlet hose
kits to fi t your specifi c installation.
2. Connect the HOT inlet hose to the HOT inlet
connection on the washer and the COLD
inlet hose to the COLD inlet connection on
the washer. Tighten by hand until snug. Then
tighten each supply connection another 2/3
turn with pliers. Do not cross thread or over-
tighten these connections.
3. Connect the HOT inlet hose to the HOT water
supply and the COLD inlet hose to the COLD
water supply. Tighten by hand until snug.
Then tighten each supply connection another
2/3 turn with pliers. Do not bend, kink or
pinch water inlet hoses.
4. Turn on the water and check for leaks.

Installation Instructions

a
c
a
USE ONLY
NEW HOSES
HOT
b
raise
d
c
COLD
e
g
lower
d
b
f
9