2.1
Chassis cover
Removing the rear cover
1.
Loosen the two thumbscrews on the rear panel to release the rear cover from
the chassis.
2.
Remove the front side screws, and
then firmly hold the cover and slide
it toward the rear panel for about
half an inch until it is disengaged
from the chassis.
3.
Lift the cover from the chassis.
4.
To recover the rear cover, reverse step 1 to 3.
A protection film is pre-attached
to the system cover before
shipping. Please remove the
protection film before turning
on the system for proper heat
dissipation.
2-2
Thumbscrews
Front side screw
Chapter 2: Hardware setup