Placing And Leveling - LG WF-HX200GV Owner's Manual

Placing and Leveling

Please ensure that transit restraint has been removed before operating your machine.
1
Place the machine on a flat and firm surface which allows proper clearance.
We suggest a minimum clearance of 2 cm to the
right side and left sides of the machine for ease of
installation.
At the rear, a minimum clearance of 10 cm is
suggested.
NOTE
If the washer is installed on a uneven,weak or tilted floor causing excessive vibration,
spin failure or " " error can happen to it.
It must be placed on a firm and level floor to prevent spin failure.
2
Make sure that the washer is properly Level
Open the lid and look from above to see if it is
same as shown.
3
Leveling the machine
Lift the front of the washing machine and twist
the Adjustable Leg until the surface bubble is
placed in the center.
4
Install Anti-Rat Cover (option)
When you are Installing it, lay the washing machine backwards.
Get rid of the sponge attached on the base.
Below following the picture, Install the Anti-Rat Cover with 8
screws into the holes.
Be careful your feet or hands when you are laying or raising the
washing machine.
Caution
If the power is supplied from a cord extension set or generator, the cord extension set or electrical
portable outlet device should be positioned so that it is not exposed to splashing or ingress of moisture.
28
more than 10 cm
more
than
2 cm
more than
2 cm
Top view of the machine
Adjustable legs
SETTING SCREW
Anti-Rat Cover