Table of Contents
Advertisement
20.
Transmission Range
The transmission distance from the thermo-hygro sensor to the base station in
open space under optimum conditions is 100ft. Although the signal
transmission may travel though solid surfaces or objects, the following points
should be avoided if possible:
•
High frequency interferences of any kind.
•
High densities of trees.
•
Broadband interferences in municipal areas can reach levels reducing the
signal/noise ratio over the entire frequency band, thus also reducing the
transmission distance.
•
Devices working close by (example a neighbor's house) may also
influence reception.
•
Poorly shielded PCs can cause interferences that will reduce or in some
cases stop reception
•
The transmitter and receiver should not be mounted on metal surfaces as
this will reduce transmission range.
21.
Cleaning and Maintenance
•
Clean the housing and screen of the base station only with a soft damp
cloth. Do not use abrasives or solvents.
•
Ensure that the rain sensor does not collect leaves or other dirt by
checking the funnel for blockages every now and then. Also clean the
seesaw of the sensor with a damp cloth and check by lightly tapping with
your finger that it can move freely from side to side.
•
Do not clean the funnel with the bottom half of the rain sensor attached
nor the bottom part itself under running water. This may bear the danger
of water entering the unit's inner parts and cause damages.
•
Do not immerse the base station in water.
•
Should there be damage to this product, please do not attempt to make
any repairs. Please take this unit to a qualified technician. Opening or
improper handling of the units will invalidate any guarantee.
22.
Specifications
Outdoor data
Transmission Distance in Open Field
Temperature Range
Resolution
Measuring Range Rel. Humidity
Rain Volume Display
Resolution
Wind Speed
Resolution
Wind Direction
Using 433MHz wireless data transmission:
Measuring interval
thermo-hygro sensor
With cable connection for data transmission:
Measuring interval
thermo-hygro sensor
Indoor data
Pressure/ temperature
Indoor Temperature Range
Resolution
Measuring Range Rel. Humidity
:
100ft max.
:
-21.8°F to +157.8°F (show OFL"
if outside range)
:
0.2°F
:
20% to 95% (if the relative
humidity is less than 20% or
greater than 95%, it will display
19% or 96%)
:
0 to 39.37 inches (1h and 24h
rainfall)
0 to 98.38 inches (Total rainfall)
:
0.1mm
:
0 to 111.8 mph
:
0.1 mph
:
Graphic Resolution 22.5
Degrees, Numerical Resolution,
Letter format
:
32 sec (if wind factor>22.36
mph) or 128sec (if wind factor
< 22.36mph) 10 minutes (if the
base station fails to receive any
data after 5 attempts in a row, all
outdoor data readings will
display "---", except for the rain
value)
:
8 seconds
:
4 times per minute
:
14.1°F to + 139.8°F (shows
"OFL" if outside range)
:
0.2°F
:
20% to 95% (if the relative
humidity is less than 20% or
Advertisement
Table of Contents
