Table of Contents
Advertisement
49
1.888.610.7664
TROUBLESHOOTING
Message
Memory Full!
There is not enough internal memory available when you try to save a label
file. Delete any unnecessary files to make more memory available for the
new label file.
Check # of
The number of digits entered in the bar code data does not match the
Digits
number of digits set in the bar code parameters. Enter the correct number
Entered!
of digits.
Input A,B,C or D
The bar code data entered does not have the required start/stop code (A,
At Start&End!
B, C, or D required at the beginning and end of the bar code data for the
CODABAR protocol). Enter the bar code data correctly.
Maximum Of
There are already five bar codes entered in the text data when you try to
5 Bar Codes
enter a new bar code. You can only use up to five bar codes in each label.
Per Label!
You can enter up to two bar codes when (AA|AA) is selected in flag layout.
Text
The text size is too large. Select a different size option.
Too High!
Installed tape
Installed tape is incompatible with this labelling system. Use compatible
is not compatible
tape.
with this machine!
System Error XX
Please contact Brother customer service.
Select Other
The tape length set using the tape length setting is shorter than the total
Cut Option!
length of the left and right margins applied for the "Large Margin" cutting
option. You have to select a different cutting option.
Line Limit!
Exceeds max. You can enter up to 100 lines in the whole page and blocks.
Max 100 Lines
per Label
Block Function
In this setting, you cannot add or delete blocks.
is Not Allowed!
Line Limit!
PUNCH-DOWN BLOCK layout allows to print up to 2 lines / block.
Max 2 Lines
This Function
PUNCH-DOWN BLOCK layout must use 9 mm or wider tape cassettes.
Requires 9mm
or Wider Tape!
Sequence Type
Texts cannot be edited when you set Sequence Type in PUNCH-DOWN
Must be None
BLOCK to Horizontal or Backbone.
When Editing!
Cassette Type
For example, Heat Shrink Tube cartridge is detected but Heat Shrink Tube
Does Not Match.
mode is not selected, or Heat Shrink Tube mode is selected but the Heat
Continue?
Shrink Tube cartridge is not inserted into the P-touch labelling system.
Error Messages
www.calcert.com
15
10
20
5
25
0
30
Cause/Remedy
sales@calcert.com
Advertisement
Table of Contents
