LG 37LB1R Series Owner's Manual page 29

!
NOTE
To enjoy vivid picture and sound, connect a PC to
G
the set.
Avoid keeping a fixed image on the set's screen for
G
a long period of time. The fixed image may
become permanently imprinted on the screen; use
a screen saver when possible.
Connect PC to the RGB (PC/DTV) or HDMI IN
G
port of the set; change the resolution output of
PC accordingly.
There might be noise according to some resolu-
G
tion, vertical pattern, contrast or brightness in PC
mode. Change the PC mode into another resolu-
tion or change the refresh rate into another rate
or adjust the brightness and contrast on the
menu until the picture is clean. If the refresh rate
of the PC graphic card can not be changed,
change the PC graphic card or consult it to the
manufacturer of the PC graphic card.
The synchronization
G
Horizontal and Vertical frequencies are separate.
In 42PC1R 50PC1R 50PC3R
*, *,
G
ommend using 1024x768, 60Hz for the PC mode,
they provide the best picture quality.
We recommend using 1360*768, 60Hz
G
(32LC2R * , 37LC2R * , 42LC2R * , 32LB1R *,
37LB1R *. 42LB1R * ) for the PC mode, they
provide the best picture quality. (
tion of PC is over UXGA, there will be no picture
on the set.)
We recommend using 1920*1 080, 60Hz
G
(47LB1R * ) for the PC mode, they provide the best
picture quality.
input waveform for
models, we rec-
*
If the resolu-
Connect the signal cable from the monitor output
G
port of the PC to the RGB (PC/DTV) port of the
set or the signal cable from the HDMI output port
of the PC to the HDMI IN port on the set.
Connect the audio cable from the PC to the
G
Audio input on the set. (Audio cables are not
included with the set).
If using a sound card, adjust PC sound as required.
G
This set uses a VESA Plug and Play Solution. The
G
set provides EDID data to the PC system with a
DDC protocol. The PC adjusts automatically when
using this set.
DDC protocol is preset for RGB (Analog RGB),
G
HDMI (Digital RGB) mode.
If required, adjust the settings for Plug and Play
G
functionally.
If graphic card on the PC does not output analog
G
and digital RGB simultaneously, connect only one
of either RGB (PC/DTV) or HDMI IN to display
the PC on the set.
If graphic card on the PC does output analog and
G
digital RGB simultaneously, set the set to either
RGB or HDMI; (the other mode is set to Plug and
Play automatically by the set.)
DOS mode may not work depending on video
G
card if you use a HDMI to DVI cable.
When you use too long RGB-PC cable, there
G
might be a noise on the screen. We recommend
using under 5m of the cable. It provides the best
picture quality.
27