Philips 43PP8445 Directions For Use Manual page 15

Using Manual Converge : Converge Red/Blue
Your projection TV has three color projection tubes : one for red, one
for green, and one for blue. When mixed in proper proportion, the
beams of light coming from the tubes can produce any color. To cre-
ate a clear picture, however, these color beams must be precisely
aligned. This alignment is called convergence. Bumps and vibrations,
moving the set, or the presence or magnetic fields can cause the color
beams to become improperly aligned, or misconverged, resulting in a
fuzzy picture. The Manual Converge controls allow you to adjust
picture convergence.
Note : Allow the TV to warm up for 20 minutes before adjusting conver-
gence.
Select MANUAL CONVERGE in the PICTURE menu.
1
Press the cursor down and select either CONVERGE RED
2
or CONVERGE BLUE.
Note : If various images in the picture have red outlines,
select CONVERGE RED. If various images in the picture
have blue outlines, select CONVERGE BLUE.
Use the cursor right, left, up, or down to adjust the cross
3
hair until the color outline is gone. The adjustment is auto-
matically saved in the TV's memory when you exit the
adjust mode.
Press the MENU key to return or the m key to switch the
4
menu off.
Check the TV picture. If any color outlines remain around
the images, use the MULTIPOINT RED (for red outlines)
or MULTIPOINT BLUE (for blue outlines) control. See
the next page for instructions for using those controls.
U M
SING THE ENUS
15
: P
ICTURE
PICTURE
MANUAL CONVERGE
•
CONVERGE RED
‰
G
•
CONVERGE BLUE
•
MULTIPOINT RED
•
MULTIPOINT BLUE
•
SAVE MULTIPOINT
• •
Converge Red
Converge Red