Frigidaire FEB24S5AB Installation Instructions Manual page 7

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
3.Insert the unit into the cabinet opening. Slide unit
inward leaving 1 3 " (3.5 cm) clearance between the
/
8
oven decorative trim and cabinet. Pull the armored cable
through the hole in the floor and toward the junction box
while moving the appliance inward. Use the second set
of holes in the side frame of the unit as a guide to find
the position of the mounting brackets on the sides of
the cabinet opening. Mark the position of the mounting
brackets as shown in Figure 8 or 9.
To reduce the risk
of personal injury
and tipping the wall
oven, the wall oven
must be secured to
the cabinet(s) by
properly installed
mounting screws or
brackets.
Figure 10 – TYPICAL UNDER COUNTER INSTALLATION OF AN ELECTRIC BUILT-IN OVEN
4.Pull out the oven approximately 1 foot (30.5 cm) away
from the cabinet. Reposition each bracket on the
cabinet and drill 1/8" pilot holes. Fasten the brackets in
place using the 2 screws supplied (#10 x 1
If needed, add wood spacers at the mounting bracket
locations to reduce the cabinet opening to 28
(72.4 cm).
Now push the unit in and against the cabinet, then
attach the unit to the mounting brackets using the 2
screws removed earlier from the side frame.
G
Cut an opening in wood base
minimum 9" x 9" (23 x 23 cm), 2"
(5 cm) from left side filler panel,
to route armored cable to the wall
outlet or junction box.
4 1/2"
(11.4 cm)
Max.
CUTOUT DIMENSIONS
F.WIDTH
30" (76.2 cm) 28 1/2" (72.4 cm) Min.
Wall Oven 29" (73.7 cm) Max.
30" SINGLE WALL OVEN ONLY
7
Side filler panels are necessary to isolate
the unit from adjoining cabinets.
36" Min.
(91.4 cm)
H
F
Use 3/4" (1.9 cm) plywood, installed
on two runners, flush with toe plate.
Must be capable of supporting 150
pounds. (68 kg).
G.DEPTH
28 1/4" (71.8 cm) Min.
24" (61 cm) Min.
28 7/8" (73.3 cm) Max.
1 " long).
/
4
1 "
/
2
H.HEIGHT