Frigidaire FRA065AT7 Use And Care Manual page 8

Operating Instructions
Operating Instructions
(continued)
REMOTE SENSING FEATURE
(on some models)：
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use
the " " buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit
itself ). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it
sends a signal. lt will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button. lf the unit
does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has
ended. The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the
unit.
FAULT CODES:
If the display reads "AS" , a sensor has failed. Contact your
Authorized Frigidaire Service Center.
TO CHANGE TEMPERATURE DISPLAY:
DO THIS:
PRESS AND HOLD THE
UP/DOWN BUTTONS
TOGETHER FOR 3 SECONDS
2009 Electrolux Home Products, Inc.
8
DO THIS:
PRESS REMOTE
SENSING
START BUTTON
NOTE: Unit display shows the set temperature
LIGHT pulsing ( On & Off intermittently ).
If the display reads "ES" , a sensor has failed. Contact your
Authorized Frigidaire Service Center.
YOU WILL SEE:
Note: The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius.
NOTE: Remote display
is actual temperature
at remote control only
All rights reserved.