Control Operation; First Use - U-Line UHBV024SG01A Quick Start Manual

QUICK START GUIDE

Control Operation

CONTROL FUNCTION GUIDE
FUNCTION
ON/OFF
Leave interior light on
Adjust Temperature
Toggle between º F / º C
Enable Sabbath Mode
Disable Sabbath Mode
Showroom Mode
This unit is Star-K certified. See www.star-k.org for more details.

First Use

Initial startup requires no adjustments. If the unit was
turned off, press and hold
See "Control Operation" section for more details.
NOTICE
Temperature displayed reflects actual tempera-
ture inside unit.
If the temperature displayed is different than selected, the
unit is progressing towards the selected temperature. Time
to reach set point varies based upon ambient temperature,
temperature of product loaded, door openings, etc. U-Line
recommends allowing the unit to reach set points before
loading.
COMMAND
Press and release
Press and release to leave interior
light on for 3 hours; press again to
deactivate
Press or and release
Hold and for 5 seconds
Press and hold for 5 seconds and
release
Press and release
Hold and for 5 seconds
for 5 seconds to turn unit on.
NOTES
Unit will turn On or OFF
After 3 hours, factory default is restored; light will
turn on when door is open
When the display is flashing, press
adjust the set point temperature. Note: temperature
displayed is the actual temperature inside unit
The display will change units
The o F / o C symbol will flash briefly after 5 seconds.
Interior light and display will go dark and remain so
until user resets mode - unit continues to operate
Display and interior light return to normal operation
Display will show
display will function normally, but the compressor
and fans will not energize.
Repeat command to return to normal operation.
Display will show
9
or
for 2 seconds. Interior light and
SH
for 2 seconds.
EH
u-line.com
to