Advertisement
INSTALLATION CONSIdERATIONS
pLACEmENT
Place the Niles System Integration Amplifier
or shelf. It should be placed upright so that its weight rests on the four attached
feet. Placing the weight of the amplifier on the rear or front panel for even an
instant will result in damage to the amplifier's connectors and controls.
The Niles System Integration Amplifier
longer if it is given adequate ventilation for proper cooling. When installing
the Niles System Integration Amplifier
the cabinet is open to fresh air to provide proper cooling (see Figure 1). If the
cabinet's design will not accommodate an open rear, install two small "boxer
fans" to provide continuous air flow into and out of the cabinet (see Figure 2).
Place the Niles System Integration Amplifier
air space above the chassis. If the amplifier is located on a carpeted surface,
place a board under the amplifier's feet. Do not block the ventilation holes on
the top and bottom of the Niles System Integration Amplifier
CAUTION! When using low impedance speaker loads (less than 8 ohms Normal
Mode) refer to Figure 2 for proper placement.
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 1-760-710-0992
9901253-Rev-A-SI-2150Manual.indd 7
Downloaded from
www.Manualslib.com
2 ChAnnEL, BRIdgABLE PowER AMPLIFIERS
Figure 1
Make sure that there is a minimum of 7" of free air
space above the amplifier for proper ventilation.
Allow a minimum of 2" of depth behind unit
to accommodate cables and connectors.
manuals search engine
on a flat level surface like a table
®
, like any hi-fi component, will last much
®
in a cabinet, be sure that the rear of
®
so that there is at least 7" of free
®
®
Figure 2
Boxer Fan (55 CFM)
directly centered 7"
on top of the SI-2125.
If the cabinet rear is not open to fresh air or if you're
using low impedance loads, install two "boxer fans"
to provide continuous air flow into and out of the
cabinet.
.
Boxer Fan (55 CFM)
directly centered 2"
behind the SI-2125.
7
6/8/12 9:43 AM
Advertisement
