GE 22 Owner's Manual And Installation Instructions page 11

Profile bottom freezer refrigerators
Table of Contents

Advertisement

Available languages

Available languages

About the freezer.
Not all features are on all models.
Appearance and features may vary
Appearance may vary
Appearance may vary
Appearance may vary
Freezer Shelves and Baskets
A shelf above the ice storage bin
A half-width basket
A shallow full-width basket
A deep full-width basket
Basket Removal
To remove the deep full-width basket on
freezer drawer models:
Open the freezer drawer until it stops.
The freezer basket rests on the inside tabs
on the drawer slides.
Lift the basket so that it is out of all 6 slide
bracket tabs.
Tilt the basket and lift out of the drawer.
To remove the half-width basket:
Pull the basket out to the stop location.
Lift the basket up at the front to release it
from the slides.
Lift the back up and out of the slide.
To remove the shallow full-width basket:
Pull the basket out to the stop location.
Lift the front up and over the stop location.
NOTE: Do not fill baskets higher than the rim of
the basket. This may cause baskets to stick or
jam when opening or closing.
When replacing the deep full-width basket:
Tilt the basket back and lower it down into
the drawer. Rotate the basket to a horizontal
position and press it down into the 6 alignment
tabs.
NOTE: Always be sure that the basket is seated
in all 6 slide bracket tabs before sliding back
into the freezer. The basket can be turned in
either direction front to back and installed into
the freezer.
When replacing the basket, make sure that
the wire tabs and wire hooks on the sides of the
basket go into the slots in the top of the upper
basket slides.
NOTE: Always be sure to fully close this basket.
Lift the basket up and out.
GEAppliances.com
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents