Cleaning The Burner Grates, Burner Caps And Burner Heads - Electrolux EW30DS65G Use And Care Manual

46
General Care & Cleaning
CLEANING THE BURNER GRATES, BURNER CAPS AND
buRneR heads
Surface Burner
1st 2nd
Surface Burner
3rd
Electrode
Orifice
Figure 1
To Clean the Burner Caps, Burner Heads and Burner Grates - Use a soap-filled
scouring pad or a mild abrasive cleaner to clean the surface burner caps and surface
burner heads. The Grates are designed to be Dishwasher safe for cleaning. The ports (or
slots) around the burner heads must be routinely cleaned. If residue still remains in these
ports, use a small-gauge wire or needle to clean the slots or holes being careful not to
damage the electrode. For proper flow of gas and ignition of the burner—DO NOT ALLOW
SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS ORIFICE HOLDER OPENING. ALWAYS make sure that the surface burner cap, the
surface burner head and the surface burner grate are properly in place whenever a surface
burner is in use.
Surface Burner Grate
the cooktoP is not ReMoVable. Do not attempt to remove or lift the cooktop.
!
cautioN
- use caution when replacing the burner head so the electrode is not damaged. a damaged electrode
may cause a delayed ignition or prevent the burner from igniting
- Any additions, changes or conversions required in order for this appliance to perform satisfactorily
must be made by a qualified service technician.
Surface Burner
The Grates, Burner Caps and the Large 18k Burner Head
Grate
should be routinely cleaned. Keeping the burner ports clean
will prevent improper ignition and an uneven flame. If needed,
the fixed burners should be cleaned in place with an humid
cloth (do not spraw water on them).
Refer to the following instructions:
To Remove and Replace the Surface Burner Grate,
Surface Burner Cap and Surface Burner Head - Remove
in the following order; (1st) Surface Burner Grate, (2nd)
Surface Burner Cap, (3rd) Surface Burner Head (See Figure
1).
Cap
Reverse the procedure above to replace the Surface Burner
Cap, Surface Burner Head and Surface Burner Grate. Do
Head
not remove any burner parts from the cooktop until
the burner parts have completely cooled and are safe
to handle. Do not operate the surface burners without
the Surface Burner Heads, Surface Burner Caps and
Surface Burner Grates properly in place.
Surface Burner Caps
Surface Burner Head